Hlt 2500-L2 (Profile Design, With Magnetic Guidance, Joint On Top) Hlt 2500-F1 (Flat Profile Design, Without Magnetic Guidance) - HYDAC ELECTRONIC HLT 2100-R1 Notice D'utilisation

12
Sealing by means of groove in cylinder base:
E
4.2 HLT 2500-L2 (profile design, with magnetic guidance, joint on top)
HLT 2500-F1 (flat profile design, without magnetic guidance)
The installation of the linear position sensor in flat profile design with magnetic guidance
is relatively simple, as the mechanical guidance of the magnet does already exist due to
the type of system. The exact guidance of the captive-sliding magnet and non-contact
and wear free measurement system complement each other optimally. In order to
reduce the wear of the magnetic guidance unit to a minimum, the dimensional
tolerances for angle and parallel misalignment must be absolutely kept.
Edition: 2017-08-31
O-ring
HYDAC ELECTRONIC GMBH
HLT 2100 / HLT 2500 SSI
non-ferrous distance ring
magnet ring
Part No.: 669999