HYDAC ELECTRONIC HLT 2100-R1 Notice D'utilisation page 39

HLT 2100 / HLT 2500 SSI
The accuracy of the measured values among others depends on the symmetry of the
magnetic field geometry. For the flat profile design without magnetic guidance, this
means that the magnet must be guided precisely with respect to the measuring system,
and parallel with regards to the axis and hight. The maximum permitted distance
between the magnet and the profile housing must not be exceeded.
The mounting kit material for the magnet should not be made of magnetisable material.
Should magnetisable material be used, a spacer made of non magnetisable material
must be used. The thickness of the non-magnetisable material must be at least 10mm at
the front and minimum 3 mm at the other sides (see fig. below). The spacer must be
installed between the magnet and its fixture. The screws must consist of non-
magnetisable material.
Edition: 2017-08-31
HYDAC position magnet ZBL MF38-18:
Distance min.
max. = 5 mm
HYDAC ELECTRONIC GMBH
= 3 mm
13
E
Part No.: 669999