Fitting The Handle; Installing/Removing The Metal Cutting Blade - Grizzly AS 4026 Lion Notice D'utilisation Originale

pic. 3
5
Ensure that the bottom shaft tube
is sitting firmly and safely before
starting the equipment.
5. Dismantling:
Loosen the tube fixing screw (7). Press
the safety button (4) and pull the tubes
apart
Fitting the Handle (Picture 4)
1. Place the handle without the speed
control lever (8) on the holder on the
upper shaft tube (3).
2. Insert the handle with the speed con-
trol lever (8) over this on the holder.
3. Screw the handles with the four Allen
screws supplied to the holder.
IB_AS_4026_Lion_B-39531_0216_TS.indb 73
3
4
7
pic. 4
3
Installing/Removing the Metal
Cutting Blade
Wear protective gloves when han-
dling the metal cutting blade.
Dismantling the reel capsule is
described in the section on "Install-
ing/Removing the Reel Capsule".
Installing the protective cover / metal
cutting blade (picture 5a):
1. Screw the protective cover onto
the cutting head holder using the 3
screws enclosed.
pic. 5a
Installing the metal cutting blade
(picture 5b):
2. Place the metal cutting blade (11) and
flanges on the cutting head holder
(11) in the following order:
Bottom flange – metal cutting blade
(11) – top flange.
3. Screw on the metal cutting blade (11)
anticlockwise
nut.
GB
using the fixing
73
24.02.16 08:12