Precautions To Prevent Recoil; Symbols In The Instructions; Symbols On The Equipment - Grizzly AS 4026 Lion Notice D'utilisation Originale

GB
- Removing or replacing the cutting de-
vice and manually adjusting the length
of the cutting thread.

Precautions to Prevent Recoil

In case of recoil, the user receives
a powerful jolt from the motorised
strimmer. This may result in loss
of control of the equipment and
in serious injury. Recoil can be
avoided by care and correct tech-
nique.
When the metal cutting blade is used,
there is a risk of recoil if the blade edge hits
an obstacle (stone, wood).
• Hold the equipment firmly in both hands.
• Ensure that there are no obstacles on
the ground and do not use the metal
cutting disk near fences, metal posts or
similar.

Symbols in the Instructions

Warning signs with details for the
prevention of personal and prop-
erty damage.
Command signs (instead of the
exclamation mark, the command is
explained) with details for the pre-
vention of damage.
Information signs with information
for better handling of the equip-
ment.
66
IB_AS_4026_Lion_B-39531_0216_TS.indb 66
Use only well sharp-
ened tools. To cut
thick stems, place the
equipment in position
A.

Symbols on the Equipment

On the equipment, there are information
symbols. These convey important infor-
mation about the product or information
about its use.
• Caution: Special safety measures are
required when handing the equip-
ment!
• The entire operating instructions must
be read and understood before use.
Non-observance of the operating in-
structions may be fatal!
WARNING!
Read the operating
instructions carefully before
using the equipment.
Wear eye protection.
Wear ear protection.
Electrical appliances must
not be disposed of with the
domestic waste.
Wear head protection.
Wear protective gloves.
Risk of injury from cuts.
Wear safety boots with stur-
dy soles.
24.02.16 08:12