Junction Box - Scrigno OPEN 2.0 Antamatic Manuel D'utilisation

Open
2.0

JUNCTION BOX

26
Caution: the electrical preparation operations must
only be performed by skilled personnel.
Note: the outlet position of the cables may differ from the
one shown alongside.
CONNECTING THE
27
Connect the 6 wires of the motor cable to the
terminal board, following the diagram colours:
WIRING DIAGRAM
BOARD SIDE MOTOR SIDE
Grey Grey
Pink Pink
Yellow Yellow
Green Green
White White
Brown Brown
CONNECTING THE
28
Choose the correct type of buttons:
SEQUENTIAL BUTTON (IMPULSIVE, NOT POWERED):
WARNING: DO NOT REMOVE the JUMPER of the CONNECTOR J3
Connection between the terminal (-B) and the terminal (CH) (closing).
With this type of button automatic reclosing can be enabled (see par. 32).
TWO SEPARATE PUSHBUTTONS (IMPULSIVE, NOT POWERED):
CAUTION: REMOVE THE J3 CONNECTOR JUMPER
Connect the common wire of the button to terminal (-B), the opening contact to terminal (AP) and the closing
contact to terminal(CH).
Jumper on connector J3
Drill the junction box using a suitable bit, fit the PG cable gland supplied with the kit, and route the button cable
through it.
R1387 DCM2461/SCRIGNO - OPEN2.0
MOTOR CABLE
OPENING BUTTONS
| pagina 60
MOTOR CABLE INLET
PG CONNECTOR for BUTTON
CABLE (not supplied)
230V POWER CABLE
TERMINAL BOARD
J3 connector
EN
Button inputs:
(dry contacts not
powered)
Close
Open
Common