Scrigno OPEN 2.0 Antamatic Manuel D'utilisation page 54

Open
2.0
Insert the block into the rail profile.
2
Note: the sign indicates the bottom side!
4
Insert the motor unit.
Make sure the 2 motor power wires are positioned
6
with the correct polarity.
-0V
Push the motor unit all the way into the rail,
8
holding back the belt. See next step for correct
position.
R1387 DCM2461/SCRIGNO - OPEN2.0
+24V
| pagina 54
Guide the rear block inside the rail by a few
3
centimetres.
Once the slot has been found, insert and tighten
5
the screw of the previously-removed block.
7
Position the belt around the pulley.
9
Correct mounting position:
1: the motor is on the bottom of the rail;
2: the belt is ON THE OUTSIDE of the motor cable.
EN
1
2