Scrigno OPEN 2.0 Antamatic Manuel D'utilisation page 59

EN
21
Tighten the belt by hand.
23
This picture shows the correct end result.
HOW TO TENSION THE BELT CORRECTLY
!
At about 20 cm from the pulley, tighten the two ends of the belt between your
thumb and the little finger of your hand. The belt is correctly tensioned if, with little
effort, you can make them touch each other.
20cm
Pulley
A belt which is too tight will be noisy, cause high power consumption and can
affect the proper operation of the system.
A belt which is too slack tends to jump over the gears.
Periodically check the belt for wear and tension.
Periodically use silicone spray if it becomes noisy.
Do not use detergents, solvents, rust sprays, or products such as Svitol® or
WD40®.
Pass the belt flap through the two free slots of the
22
junction bracket, locking it in place.
Cut off the excess part of the belt.
Adjust the belt tension by screwing or unscrewing
24
the bolt (A) with the allen wrench.
IMPORTANT! The pulley must be free to move!
25
Belt
Open
A
After completing the
operation, tighten the bolt (B).
B
R1387 DCM2461/SCRIGNO - OPEN2.0
2.0
| pagina 59