Promac 212VLL Manuel De L'utilisateur page 30

DISCONNECT
DRILL PRESS FROM THE POWER SOURCE BEFORE
INSTALLING, ADJUSTING, OR REMOVING THE
CHUCK.
FIG.10
4
1
To install the chuck (Fig. 10)
1. Inspect and clean the taper hole in the chuck
(1) and the spindle (2). Remove all grease, coatings,
and particles from the chuck and spindle surfaces with a
clean cloth.
2. Open the chuck jaws (3) by manually turning the
chuck barrel clockwise. Make sure the jaws are completely
recessed inside the chuck.
3. Insert the chuck arbor (4) into the opening at the top
of the chuck (1).
4. Seat the chuck and chuck arbor on the spindle by
placing a block of wood (5; not included) under the chuck
(1) and tapping the wood with a hammer (6; not included)
or tap the chuck with a rubber mallet (not included).
To avoid damaging the chuck,
make sure the jaws are completely recessed into the
chuck. Do not use a metal hammer to drive the chuck
into the spindle.
FIG.11
3
4
THE BENCH
2
4
1
3
6
2
1
28
To remove the chuck (Fig. 11)
1. Turn the feed handles (1) to lower the chuck
(2) to the lowest position.
2. Place a ball joint separator (3; not included) above
the chuck and tap the separator lightly with a hammer (4;
not included) to cause the chuck to drop from the spindle.
Note: To avoid possible damage to the drill or chuck, be
prepared to catch the chuck as it falls.
FIG.12
1
2
To install the safety goggles (Fig. 12)
1. Insert the rod (2) into the rod base (1) and fix the
screw (3) through the gasket (4).
2. Fix the screw (5) through the rod base.
3. Put the goggle (6) on the rod and fix it with screws
(7).
ADJUSTMENTS
FIG.13
To raise or lower the table (Fig. 13)
1. Loosen the support lock handle (1) and turn the
crank handle (2) until the table is at the desired height.
2. Tighten the table lock before drilling.
To rotate the table (Fig. 13)
3
4
5
7
6
1
2