Promac 212VLL Manuel De L'utilisateur page 28

A Head/motor assembly
B Column assembly and table bracket
C Table
D Base
E Chuck
F Chuck key
G Table lock handle
H Hex head bolts (4)
I Table crank handle
J Hex keys (2)
ASSEMBLY
The column assembly (column, column support, rack, rack
collar, and table support bracket) must be attached to the
base. The table and table support handles must be
attached to the table support bracket. The motor housing
must be attached to the column.
IF ANY PART IS MISSING OR
DAMAGED, DO NOT PLUG THE BENCH DRILL PRESS
IN UNTIL THE MISSING OR DAMAGED PART IS
REPAIRED OR REPLACED, AND ASSEMBLY IS
COMPLETE.
Tools needed for assembly
• Adjustable wrench
• Screwdriver
• Hammer and block of wood
FIG.3
1
2
Column assembly to base (Fig. 3)
1. Place the column tube (1) on the base (2), aligning
the column support holes to the base holes.
K Feed and speed handles (4)
L LED bulb
M Table adjustment wrench
N Wedge
O Goggle rod
P Safety goggle
Q Screw gasket
R Goggle rod shaft screw
S Fixing bolt of goggle rod
T Safety goggle screws (2)
2. Install a hex head bolt (3) in each column support
hole and tighten bolts using the adjustable wrench.
FIG.4
Table (Fig. 4)
1. Place the crank handle (1) onto the shaft(2) of the table
bracket so the flat of the shaft is under the set screw (3).
3
Tighten the set screw.
FIG.5
4
26
1
2 3