What To Do In Case Of A Problem - BORETTI BIK-38 Notice D'emploi

What to do in case of a problem

When the symbol [ E 4 ] appears :
• The table must be reconfigured. Please implement the following steps :
I) Important : before you start, make sure there is nothing on the hob
II) Disconnect the appliance from the power supply by removing the plug, fuse or turning the
circuit breaker off
III) Reconnect the table to the grid
IV) Procedure : take a pot with a ferromagnetic bottom and a minimum diameter of 16 cm
* start the procedure within 2 minutes after reconnecting the hob to the grid
* don't use the [
V) First step : cancel the existing configuration
1) Push on the locking key and keep your finger on the key.
2) With a finger from the other hand activate successively and quickly a - b - c keys. Start from
left to right. A double "beep" sound will inform you of a bad manipulation and you will have to
restart from point 1.
A
3) The left display shows alternatively a [ C ] and a [ 0 ].
4) Press the key lock until both displays indicate either [ C ] or [ - ].
5) Take your fingers away from the keys and press again the [ - ] key during a few seconds until
some [ E ] appear.
6) You will hear a "beep" sound and the [ E ] will blink.
7) The [ E ] are automatically transformed into [ C ]. The configuration has been canceled.
VI) How to configure the hob ?
1) Use a suitable induction pot with a minimum diametre size of 16cm.
2) Select the heating zone by pushing the corresponding [ + ] key.
3) Put the pot on the corresponding heating zone.
4) Wait until [ C ] converts to [ - ]. The zone is configured
5) Use the same procedure for each other heating zone which displays [ C ]
6) The configuration is made if all zones are detected and if nothing is displayed
Use only 1 pot to configure the hob.
Never put two or more pots on the heating zones during the configuration.
• If [ E 4 ] displaying remains, please call the customer care
60
] touch
B C