Electrical connection
• The installation of this appliance and the connection to the electrical network should be en-
trusted only to an electrician whom is aware of the local regulations and which respects them
scrupulously.
• Protection against the parts under tension must be ensured after the building-in.
• The necessary data for connection are on the stickers placed on the hob casing near the con-
nection box.
• The connection to the main must be made using an earthed plug or via an omni polar circuit
breaking device with a contact opening of at least 3 mm.
• The electrical circuit must be separated from the network by adapted devices, for example:
circuit breakers, fuses or contactors.
Caution!
This appliance is only to be connected to a network 230 V~ 50 Hz.
Always connect the earth wire.
Respect the connection diagram.
The connection box is located underneath, at the back of the hob casing. To open the cover use a
medium screwdriver. Place it in the slits and open the cover.
Mains
230V~1P+N 50Hz
* calculated with the simultaneous factor following the standard TN 60 335-2-6/1990
Connection of the hob
Setting up the configurations:
For the various kinds of connection, use the
brass bridges which are in the box next to the
terminal
Monophase 230V~1P+N
Put the 1st bridge between terminal 1 and 2,
the 2nd between 3 and 4.
Attach the earth to the terminate "earth", the
neutral N to terminal 3 (or 4), the Phase L to
one of the terminals 1 or 2.
Boretti cannot be held responsible for any incident resulting from incorrect connection
or which could arise from the use of an appliance which has not been earthed
Connection
Cable diameter Cable
1 Phase + N
3 x 2,5 mm²
or has been equipped with a faulty earth connection.
H 05 VV - F
H 05 RR - F
Caution! Ensure that you correctly attach the
wires and the bridges. Tighten the screws
properly. Before making the connection, we
strongly advise you to locate the phase(s), neu-
tral and earth on the mains. Note: the bridges
between terminals 4-5 and between terminals
1-2 were installed during the factory check.
Protection calibre
16 A *
NL
FR
D
EN
63