Specifications; Sound Values And Vibration Values - Stihl RMA 765 V Notice D'emploi

20 Specifications

Fault LEDs on the ope‐
rating unit
during opera‐
tion.
The lawn
mower opera‐
ting time is
too short.
20 Specifications
20.1 Lawn Mower STIHL
RMA 765.0 V
Permitted batteries:
– STIHL AR L
– STIHL AP together with ADA 700 double-
battery compartment
– Weight without battery: 44 kg
– Maximum grass catcher box capacity: 80 l
– Cutting width: 63 cm
– Speed: 3300 rpm
– Speed in ECO mode: 2800 rpm
For information on the battery life see
www.stihl.com/battery-life.
20.2 Blades
– Minimum thickness a: 2.2 mm
– Minimum width b: 30 mm
0478-131-9938-C.VA2.M20.
LEDs on the Cause
battery
The blades are
blocked.
There is an elect‐
rical fault.
The battery is not
fully charged.
The battery ser‐
vice life has been
exceeded.
– Minimum width c: 26 mm
– Sharpening angle d: 30°
20.3
The K value for the sound pressure level is
3 dB(A). The K value for the sound power level is
1.2 dB(A). The K value for the vibration values is
0.7 m/s².
– Sound pressure level L
ance with EN 60335-2-77: 84 dB(A)
– Sound power level L
ance with 2000/14/EC: 92.2 dB(A)
– Vibration value a
with EN 60335-2-77, handlebar: 1.4 m/s²
The indicated vibration values have been meas‐
ured in accordance with a standardised test
method and can be used for the purpose of com‐
paring electrical appliances. The actual vibration
values that occur may deviate from the indicated
values, depending on the type of application.
The indicated vibration values can be used for an
initial assessment of the vibration load. The
actual vibration load must be assessed. Times
during which the electrical appliance is switched
off, along with times in which it is switched on but
running without load, can also be taken into con‐
sideration.
Remedy
► Allow the lawn mower to cool
down.
► Clean the lawn mower.
► Do not switch the lawn mower
on too frequently within a short
time.
► If working with self-propulsion
engaged: set a lower speed.
► If working with self-propulsion
disengaged: go forwards slo‐
wer.
► Set a higher cutting height.
► Mow shorter grass.
► Pull out the activation key.
► Remove the battery.
► Clean the lawn mower.
► Remove the battery and fit it
again.
► Switch the lawn mower on.
► Fully charge the battery.
► Replace the battery.
Sound Values and Vibration
Values
measured in accord‐
pA
measured in accord‐
wA
measured in accordance
hv
English
37