Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4
MAINTENANCE
GB

4.20 STORAGE

General
1.
Wash the tractor thoroughly and
lubricate. Repair and paint damaged or
exposed metal.
2.
Inspect the tractor, tighten all hardware,
replace worn or damaged components.
3.
Drain and refill radiator.
4.
Clean the tires thoroughly and store the
tractor so the load is off the tires. If
tractor is not on jack stands, check tires
at regular intervals and reinflate as
necessary.
5.
Keep the machine and all its accessories
clean, dry and protected from the
elements during storage. Never store
equipment near an open flame or spark
which could ignite fuel or fuel vapors.
Battery
1.
Remove, clean and store battery in
upright position in a cool, dry place.
2.
Check and recharge battery every 60 to
90 days while in storage.
3.
Store batteries in a cool, dry place. To
reduce the self discharge rate, room
temperature should not be above 80°F
(27°C) or fall below 20°F (-7°C) to
prevent electrolyte from freezing.
Engine (General)
1.
While the engine is warm, remove the
drain plug, drain the oil from the
crankcase and change oil filter. Install
drain plug and refill with fresh oil. Let
engine cool before starting.
2.
Clean exterior of engine. Paint exposed
metal, or apply a light coat of rust
preventative oil.
3.
Add a fuel conditioner or biocide to
prevent gelling or bacterial growth in fuel.
See your local fuel supplier.
JACOBSEN GREENS KING V PLUS
MAINTENANCE AND PARTS MANUAL
Cutting Units
1.
Wash the cutting units thoroughly, then
repair and paint any damaged or exposed
metal.
2.
Lubricate all fittings and friction points.
3.
Backlap the reels then back the reel away
from the bedknife. Apply a light coat of
rust preventative oil to the sharpened
edges of the reel and bedknife.
CAUTION
To prevent personal injury and damage
to the cutting edges, handle the reel with
extreme care.
After Storage
1.
Check and reinstall battery
2.
Check or service fuel filter and air cleaner.
3.
Check the radiator coolant level.
4.
Check oil level in the engine crankcase
and hydraulic system.
5.
Fill the fuel tank with fresh fuel. Bleed the
fuel system.
6.
Make certain that the tires are properly
inflated.
7.
Remove all oil from the reels and
bedknife. Adjust bedknife and cutting
height.
8.
Start and operate the engine at 1/2
throttle. Allow enough time for the engine
to become properly warmed and
lubricated.
WARNING
Never operate the engine without proper
ventilation; exhaust fumes can be fatal
when inhaled.
GB-21

Publicité

Table des Matières
loading

Table des Matières