Maintenance & Lubrication; Lubrication Chart - Jacobsen Greens King V Plus Manuel De Maintenance

6 MAINTENANCE & LUBRICATION
GB
6.1 GENERAL
WARNING
Before you clean, adjust, or repair this
equipment, disengage all drives, lower
implements to the ground, engage
parking brake, stop engine and remove
key from ignition switch to prevent
injuries
1. Always clean the grease fitting before
and after lubricating.

6.2 LUBRICATION CHART

A Reel Swivel Housings (3 Fittings)
B Lift Arms (3 Fittings)
C Cam (3 Fittings)
D Treadle
E Steering Shaft
JACOBSEN GREENS KING V PLUS
MAINTENANCE AND PARTS MANUAL
2. Lubricate with grease that meets or
exceeds NLGI Grade 2 LB specifications.
Apply grease with a manual grease gun
and fill slowly until grease begins to seep
out. Do not use compressed air guns.
3. Periodically apply a small amount of
lithium based grease to the seat runners.
4. For smooth operation of all levers, pivot
points and other friction points that are not
shown on the lubrication chart apply
several drops of SAE 30 oil every 40 hours
or as required.
Grease fittings (A - D) every 50 hours and
5.
fittings (E -K) every 100 hours.
F Rear Wheel Bearings
G Rollers (6 Fittings)
H Lift Arm Shafts
J Steering Cylinder Pivot
K Reel Bearing Cavities
GB-23