Water Supply And Drain Connections - Hoshizaki KM H Série Notice D'utilisation

must be connected to the terminal which is marked
with the letter "N" or coloured Black. The wire which is
coloured Brown must be connected to the terminal
which is marked with the letter L or coloured Red.
If the non-rewirable plug has been cut from the power
supply cord, it must be disposed of. There should be
no attempt to reuse it. Inserting such a plug into a
socket elsewhere presents a serious risk of electrical
shock.
For the U.K. and the Republic of Ireland only For the U.K. and the Republic of Ireland only For the U.K. and the Republic of Ireland only For the U.K. and the Republic of Ireland only For the U.K. and the Republic of Ireland only
• The non-rewirable plug must never be used without a
fuse cover being fitted.
• The correct replacement for the detachable fuse cover
is identifiable from the manufacturer's reference number
stamped on the plug.
• Supply of replacement fuse covers can be obtained
from Hoshizaki Parts/Service Centres.
• Fuses should be rated at 13A and approved to BS
1362.
For KM-1300S_H-E only For KM-1300S_H-E only For KM-1300S_H-E only
For KM-1300S_H-E only For KM-1300S_H-E only
A suitably sized power supply cord (see the rating on
the Nameplate) must be fitted by a qualified installer
into the Terminal Box on the rear of the machine. The
wires in the terminal box are coloured in accordance
with the following code:
Green & Yellow = Earth
Blue = Neutral
Brown = Live

3. WATER SUPPLY AND DRAIN CONNECTIONS

3. WATER SUPPLY AND DRAIN CONNECTIONS 3. WATER SUPPLY AND DRAIN CONNECTIONS
3. WATER SUPPLY AND DRAIN CONNECTIONS 3. WATER SUPPLY AND DRAIN CONNECTIONS
Note: A plumbing permit and services of a licensed
plumber may be required in some areas.
• Only potable water should be used for this icemaker.
• Water supply pressure should be minimum 0.7 bar and
maximum 8 bar. If the pressure exceeds 8 bar, use a
pressure reducing valve. Do NOT throttle back the
supply tap.
• The icemaker drain is gravity flow, so ensure that the
drainpipe has an adequate pitch or fall.
• Water should drain into an open trap.
91A1NG10A0105
II. OPERATING INSTRUCTIONS II. OPERATING INSTRUCTIONS
II. OPERATING INSTRUCTIONS II. OPERATING INSTRUCTIONS II. OPERATING INSTRUCTIONS
1. This icemaker is designed to produce edible
ice. To keep the icemaker hygienic:
• Wash your hands before removing ice.
• Use the Plastic Scoop provided
(accessory).
• The Storage Bin is for ice use only. Do not
store anything else in the Bin.
• Clean the Storage Bin before use (see "III.
1. CLEANING").
• Keep the Scoop clean. Clean it by using a
neutral cleaner and rinsing thoroughly.
• Close the Door after removing ice to pre-
vent entrance of dirt, dust or insects into
the Storage Bin.
2. The use of any electrical equipment involves
the observance of some fundamental rules.
In particular:
• Instances of high humidity and moisture
increase the risk of electrical short circuits
and potential electrical shocks. If in doubt,
disconnect the icemaker.
• Do not pull the power cord in order to
disconnect the icemaker from the feed
network.
• This appliance is not suitable for unsuper-
vised use by young children or aged or
infirm persons.
3. All parts are factory-adjusted. Improper
adjustments may result in failure.
4. If the unit is turned off, wait for at least 3
minutes before restarting the icemaker to
prevent damage to the Compressor.
1. OPERATION 1. OPERATION 1. OPERATION
1. OPERATION 1. OPERATION
The installer will normally commission the icemaker to
start the automatic icemaking process. To ensure
continuous operation, make sure that:
• The water supply tap is on, and
• The power supply is on.
3
ENGLISH ENGLISH
ENGLISH ENGLISH ENGLISH
WARNING WARNING WARNING
WARNING WARNING