As3X Reaction Test - Spectrum AR10360T Guide De L'utilisateur

AS3X Reaction Test

This test ensures that the AS3X control system is functioning properly.
1.
Assemble the aircraft, bind your transmitter to the receiver, and complete
the AS3X First Time Setup in the Forward Programming menu before
performing this test.
2.
Raise the throttle above 25% to activate AS3X, then lower the throttle.
Once the AS3X system is active, control surfaces move in respose to
aircraft movement. AS3X remains active until the battery is disconnected.
CAUTION: Activate throttle cut to prevent motor operation during this
test.
3.
Move the aircraft as shown and ensure the control surfaces move in the
direction indicated in the graphic. If the control surfaces do not respond as
shown, do not fly the aircraft.
Aircraft Movement
4.
If the control surfaces do not respond as shown, review the receiver
mounting orientation.
1. In your transmitter's menu select
Forward Programming -> Gyro Settings -> System Setup ->
Orientation
2. Verify the receiver orientation matches the selected diagram. The image
of the airplane is from the top. If your access to the receiver is from the
bottom, remember the images on the screen need to match the way
the receiver sits in the model when it is upright.
Control Surface Reaction
EN
9