Troubleshooting Guide - Spectrum AR10360T Guide De L'utilisateur

EN

Troubleshooting Guide

Problem
Aircraft will not
respond to throttle
but responds to
other controls
Aircraft will not
Bind (during bind-
ing) to transmitter
22
Possible Cause
Throttle not at idle
and/or throttle trim
too high
Throttle servo travel
is lower than 100%
Throttle channel is
reversed
Motor disconnected
from ESC
Transmitter too
near aircraft during
binding process
Aircraft or transmitter
is too close to
large metal object,
wireless source or
another transmitter
The bind plug is not
installed correctly in
the bind port
Flight battery/
transmitter battery
charge is too low
Bind button not held
long enough during
bind process
Solution
Reset controls with throttle
stick and throttle trim at
lowest setting
Make sure throttle servo travel
is 100% or greater
(With battery disconnected
from aircraft) Reverse throttle
channel on transmitter
Make sure motor is connected
to the ESC
Move powered transmitter
a few feet from aircraft, dis-
connect and reconnect flight
battery to aircraft
Move aircraft and transmit-
ter to another location and
attempt binding again
Install bind plug in bind port
and bind the aircraft to the
transmitter
Replace/recharge batteries
Power off and repeat bind
process