Spectrum AR10360T Guide De L'utilisateur page 13

Adding Flight Modes outside of Forward Programming
(in the transmitter)
Flight Modes outside of forward programming are set up in the main
transmitter menu and are separate from Flight Modes set up within forward
programming. Flight Modes in the transmitter tie together transmitter-based
features like dual rates and expo, selected channels and positions, trim, and
voice/sound features.
1.
Select Model Setup -> Flight Mode Setup
Assign a switch for the flight mode selection. See your transmitter manual
for more information about setting up Flight Modes on your transmitter.
2.
Select Model Setup -> Channel Assign
Link the functions by assigning the Flight Mode channel. Select the same
Flight Mode channel you picked within forward programming, set the
switch to Flight Mode.
3.
Select Model Setup -> Digital Switch Setup
Match the Flight Mode functions. Select Flight Mode in the switch
selection, a set of values appears for each flight mode.
Set Flight Mode 1 to 100%, Flight Mode 2 to 0%, and Flight Mode 3 to
-100%.
4.
Select Forward Programming -> Gyro Settings -> F-Mode Setup
Verify the flight modes change as expected when moving the Flight Mode
Switch.
5.
(Only applies to transmitter with trimmer switches, DX9 and higher)
If you wish to be able to run a trimmer for gain independent for each flight
mode, Select Model Setup -> Trim Setup
Select F-Mode for the trimmer that is assigned to gain.
SAFE Setting menu.
The First Time SAFE Setup should be sufficient to fly your airplane, but to
fine tune the SAFE system there are many setup and tuning options.
Select Forward Programming -> Gyro Settings -> SAFE Settings ->
• SAFE Gains can be fine tuned for each axis within each Flight Mode.
• Angle Limits can be changed for each flight mode
• Fixed/ Adjustable Gain operates the same as this feature in AS3X, but
applies to SAFE gain. You can assign a separate SAFE gain channel for roll
and pitch if you have enough free channels. Use a different gain channel
for SAFE gain than what you have assigned for AS3X. It is possible to have
up to five different channels assigned for fine tuning gain. AS3X roll, pitch
and yaw, and SAFE roll and pitch. If you are limited by channels, make your
gain changes within Forward Programming.
• Capture Gyro Gains operates the same as this feature in AS3X, but
applies to SAFE operation
EN
13