Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Selecting the right accessory
Task
Sawing
Sanding
Removing grout
Scraping
We recommend you purchase your accessories from the same store that sold you the multi-tool. Always use good quality accessories. Choose the type according to the task at hand. Refer to the
accessory packaging for more information.
Fitting the sanding pad & sanding sheets
1. Lift the Keyless Change Lever (4) and push forward then rotate the lever anti-clockwise to
loosen and remove the Flange (12)
2. Insert the sanding pad onto the multi-tool then insert the Flange and tighten by rotating the
lever clockwise
3. Return the Keyless Change Lever to the original position on the multi-tool
4. Select the required sanding sheet for you intended task (see 'Selecting the right grade of
sanding sheet' below)
5. The sanding pad and sanding sheets use a hook and loop system for attachment. To mount
the sheet, line up one corner of the sheet with a corner of the sanding pad and gradually
push the rest of the sheet onto the pad, checking alignment as you do so, until the sheet is
fitted correctly (Fig. V)
6. Firmly press the multi-tool with the installed sanding sheet against a flat surface and briefly
switch the tool ON. This provides good adhesion and prevents premature wear
Note: If one point has become worn after use, carefully pull off the sanding sheet, turn it 120°,
and re-install following steps 5 and 6.
Pic
Bi-metal metal/wood end cut blade
HSS segment saw blade
Sanding base
Diamond-coated segment saw blade
Rigid scraper blade
Selecting the right grade of sanding sheet
• Sanding sheets are available in a variety of different grades: coarse (60 grit), medium (120
grit) and fine (240 grit)
• Use a coarse grit to sand down rough finishes, medium grit to smooth the work, and fine
grit to finish off
• Always use good quality sanding sheets to maximise the quality of the finished task
• It is advisable to do a trial run on a scrap piece of material to determine the optimum
grades of sandpaper for a particular job. If there are still marks on your work after sanding,
try either going back to a coarser grade and sanding the marks out before recommencing
with the original choice of grit, or try using a new piece of sandpaper to eliminate the
unwanted marks before going on to a finer grit and finishing the job
Name
Wood, plastic, fiberglass, nails, non-ferrous
metals, thin sheet metal, hardened fillers
Thin wood, plastic, fiberglass, non-ferrous
metals, thin sheet metal, hardened fillers,
window glazing
Wood, plastic, hardened fillers
Ceramic and stone tile, backerboard
Old paint, hardened adhesive, caulk, carpet
Application
GB
7
Publicité
Table des Matières
