Supplied; Special Warnings For The Metering Of Sulphuric Acid (Max. 50%); Operational Instructions (Commissioning); Control Panel - ETATRON D.S. eOne PLUS Notice D'installation, Mode D'emploi, Notice D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Supplied

The following is supplied with the pump:

SPECIAL WARNINGS FOR THE METERING OF SULPHURIC ACID (MAX. 50%)

In this case it is essential to bear in mind the following:
If the equipment is not attached to the system you can carry out this operation, by activating the pump for a few
seconds (15-30) holding it upside down with no tubes connected to the fittings, if that is not possible then disassemble
and reassemble the pump body (Fig .10), via the four fixing screws.

OPERATIONAL INSTRUCTIONS (COMMISSIONING)

Control Panel

ENGLISH
58
4 m of PVC flexible transparent suction tube
2 m semi-rigid polyethylene opaque delivery hose
n. 1 3/8 "- ½" BSP injection valve
n. 1 bottom filter
n. 1 set of instructions
replace the transparent PVC suction hose with a semi-rigid polyethylene delivery tube.
remove in advance all the water present in the pump body, in fact if this is mixed with the sulphuric acid it
generates a strong concentration of gas resulting in the overheating of the area causing damage to the
valves and the pump body.
1
Start and Stop button
2
Values increase and scroll the menu to right button
3
Values reduction and scroll the menu to left button
4
Button, access to sub-menus, to CONFIRM your choice
5
Exits to sub-menus button
Yellow LED flow status alarm / power failure alarm / maximum acceptable impulse
6
difference alarm
7
Injections signalling red LED
8
Bi-colour LED pump powered / Stand by
9
Graphic Display
Fig. 8 – Control and Display Panel

Publicité

Table des Matières
loading

Table des Matières