Maintenance; Recommended Maintenance Operations; Control And Cleaning Of The Brush - Fimap FM43 Manuel D'utilisation Et D'entretien

TYPE OF MAINTENANCE
Checking and cleaning the pad holder
Checking and cleaning the solution tank (optional)
Careful cleaning of the brush guarantees better cleaning of the floor
as well as a longer brush motor life. To clean the pad holder, proceed
as follows:
1. Take the appliance to the dedicated dirty water drainage area.
ATTENTION: The place this operation is carried out should
comply with current environmental protection regulations.
1
3. Check that the handlebar is in the vertical position, if not, press
the uncoupling lever (4) (Fig.2) and turn the handlebar to the
vertical position (Fig.3). When the handlebar is vertical, release
the uncoupling lever (4).
4. Tip the appliance back (Fig.4), block one of the rear wheels and
shift the control column backwards.
5. Turn the brush clockwise to release it from the hub present in the
brush head (Fig.5).
4

MAINTENANCE

RECOMMENDED MAINTENANCE OPERATIONS

CONTROL AND CLEANING OF THE BRUSH

2. Check that the plug (1) on the power cable (2) has been taken out
3
1
2
2
6. Remove the brush from the appliance (Fig.6).
7. Clean the brush under running water and remove any impurities
8. Repeat the operations in reverse order to reassemble all the
5
29
X
X
of the socket (3) of the mains supply(Fig.1), and if not, disconnect
it.
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
4
3
present in the bristles of the brush. Check the bristles. If they are
excessively worn, replace the brush (the bristles should protrude
by at least 10mm).
parts.
6
X X
X X