Manoeuvrability Of The Appliance; At The End Of The Work - Fimap FM43 Manuel D'utilisation Et D'entretien

The first time an operator uses the appliance, he/she should become
familiar with the movements to be imparted to the shaft in order
to be confident enough with the directionality of movement of the
appliance, and should therefore not operate the appliance near
people or obstacles.
Work in slow movements to the right and left, possibly moving back
so that the operator always stands on an area of the floor yet to be
cleaned up.
Keep the power supply cable behind the operator, taking care not to
1
At the end of the work, and before carrying out any type of
maintenance, perform the following operations:
1. Disconnect the plug (1) of the power supply cable (2) in the mains
supply socket (3) (Fig.1).
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
1
ATTENTION: During this operation, do not rest your foot on
the appliance.
3. Tip the appliance back and take it to the maintenance
area and carry out all the procedures listed in the section
"RECOMMENDED PERIODIC
column "AT THE END OF THE WORK".

MANOEUVRABILITY OF THE APPLIANCE

2

AT THE END OF THE WORK

3
1
2
2
MAINTENANCE" indicated in the
28
operate the appliance in its vicinity in order not to damage it.
Do not insist too much on the same area so as to avoid damaging
the floor, also in function of the type of brush or abrasive floor pad
chosen.
When working, the appliance will move to the right by slightly lifting
the handlebars (Fig.1).
When working, the appliance will move to the left by slightly
lowering the handlebars (Fig.2).
ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
2. Turn the handlebar to the vertical position, press the uncoupling
lever (4) (Fig.2) and turn the handlebar to the vertical position
(Fig.3). When the handlebar is vertical, release the uncoupling
lever (4).
4
3
4. Once the maintenance work is finished take the appliance to the
designated machine storage place.
ATTENTION: Park the appliance in an enclosed place, on a
flat surface; near the appliance there must be no objects that
could either damage it, or be damaged through contact with it.