Maintenance, Troubleshooting; Safety Instructions; Ordering Spare Parts; Storage, Disposal - Burkert 0290 Manuel D'utilisation

Electrovanne a 2/2 voies
Masquer les pouces Voir aussi pour 0290:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

max. 1 Nm
Fig. 1:
Electrical installation
Tighten cable plug (for permitted types see data sheet), observing
max. torque 1 Nm.
Check that seal is fitted correctly.
Connect protective conductor and check electrical continuity between
coil and body.
8
6.2 Malfunctions
If malfunctions occur, check whether:
• the device has been installed according to the instructions,
• the electrical and fluid connections are correct,
• the device is not damaged,
• all screws have been tightened,
• the voltage and pressure have been switched on,
• the pipelines are clean.
Malfunction
Possible cause
Valve does not
Short-circuit or coil interrupted
switch
Medium pressure outside the permitted
pressure range
core / core area is dirty
Valve does not close Internal space of the valve is dirty
If the valve still does not switch, please contact your Bürkert Service.
7.2 Overview of replacement spare sets
SET 1 = coil set
SET 3 = wearing parts set
DN 12
DN 20, DN 25
SET 1
SET 3
Fig. 2:
Overview of replacement spare sets
10
Seal
Authorized cable plug
e.g. Type 2508 or other suitable
cable plug in accordance with
DIN EN 175301-803 Form A
english
DN 32, DN 40,
DN 50, DN 65
SET 1
SET 1
SET 3
SET 3
english
6

MAINTENANCE, TROUBLESHOOTING

6.1 Safety instructions

DANGER!
Risk of injury from high pressure in the equipment!
▶ Before loosening the lines and valves, turn off the pressure and
vent the lines.
Risk of injury due to electrical shock!
▶ Before reaching into the system, switch off the power supply and
secure to prevent reactivation!
▶ Observe applicable accident prevention and safety regulations for
electrical equipment!
WARNING!
Risk of injury from improper maintenance!
▶ Maintenance may be carried out by authorized technicians only and
with the appropriate tools!
Risk of injury from unintentional activation of the system and an
uncontrolled restart!
▶ Secure system from unintentional activation.
▶ Following maintenance, ensure a controlled restart.
7
SPARE PARTS
CAUTION!
Risk of injury and/or damage by the use of incorrect parts!
Incorrect accessories and unsuitable spare parts may cause injuries and
damage the device and the surrounding area.
▶ Use only original accessories and original spare parts from Bürkert.

7.1 Ordering spare parts

The spare parts sets SET 1 (coil set) or SET 3 (wearing parts set) can
be ordered by quoting the identification number of the device.
english
8
PACKAGING, TRANSPORT,

STORAGE, DISPOSAL

NOTE!
Transport damages!
Inadequately protected equipment may be damaged during
transport.
• During transportation protect the device against wet and dirt in
shock-resistant packaging.
• Avoid exceeding or dropping below the allowable storage
temperature.
Incorrect storage may damage the device.
• Store the device in a dry and dust-free location!
• Storage temperature -40 ... +55 °C.
Damage to the environment caused by device components con-
taminated with media.
• Dispose of the device and packaging in an environmentally friendly
manner.
• Observe applicable regulations on disposal and the environment.
Type 0290
9

Publicité

Table des Matières
loading

Table des Matières