Eurosystems Z2 Mode D'emploi page 14

viscosity SAE 80 ). Proceed as follows: A) loosen the screw cap (1). B) place the machine at an angle and suck up the oil using a syringe. C) fill up with
about 0.2 litres of new oil for the model of motor hoe with width 40 cm; about 0.5 litres for the model of motor hoe with width 50 cm.
To check the oil level: Place the machine in horizontal position; unscrew the cap and make sure the oil is at the lowest level of the hole. The filler and
emptying cap corresponds to the level of the oil.
SERVICING FOR THE HOE TILLERS
residues, grass, iron wires, etc. etc.
MAINTENANCE ENGINE (see engine manual)
overflows. Capacity O.500 kg approx. Use oil type MULTIGRADE viscosity to be 10 - 40 W.
GARAGING AND SCHEDULED MAINTENANCE
good machine working on safety conditions. Leave the machine to cool before garaging anyhow don't room it if the tank contains still contains some fuel as
the vapours could reach some blazes or sparks. To lower the fire danger , keep the engine , the silencer and the fuel area free from leaves , grass or greasy
substances.
DESCRIPTION OF THE MACHINE COMPONENTS (Fig. 8)
gear control lever. 4) Motor pull-start handle. 5) Cutting adjustment drewbar. 6) Cutters. 7) Cutter guard. 8) Plant protection discs (for mod. Z3 only).
TECHNICAL DETAILS OF MOTOR HOE MOD. Z2
complete with protection guard. Top cutter rotation speed is 120 rpm approx. Transmission : single speed or single speed+reverse speed. Weight of
the complete motor hoe is 32 kg. Motor hoe dimensions: max length 1.30 m max width 0.40 m height 1.10 m.
TECHNICAL DETAILS OF MOTOR HOE MOD. Z3
complete with protection guard. Top cutter rotation speed is 130 rpm approx. Transmission : single speed or single speed+reverse speed. Weight of
the complete motor hoe is 44 kg. Motor hoe dimensions: max length 1.30 m max width 0.50 m height 1.10 m.
NOISE AND VIBRATION LEVEL
with EN and ISO 5349. Level max detected = 7,2 m/s
ACCESSORIES FOR MOTOR-HOE MOD. Z2
blower. 4) 16 cm cutter.
ACCESSORIES FOR MOTOR-HOE MOD. Z3
8
cutter widening with guard.
Clean the tiller hubs, the tiller-shaft and the cutting hoe parts making sure they are free from soil
Attention - The motor-cultivator is delivered without oil in engine. Replenish tank until oil
Keep attention that all the nuts ,screws and bolts are tightened in order to guarantee a
Motor: for details, see the specific publication. Working width of cutters is 40 cm,
Motor: for details, see the specific publication. Working width of cutters is 50 cm,
Max noise level LWA = 89 dB (A) for mod. Z2 and 93 dB (A) for mod. Z3. Handlebar vibration in compliance
2 for mod. Z2 and 8,6 m/s 2 for mod. Z3.
1) Fixed-wing ridger with coupling. 2) Spring lawn weeder complete with guard. 3) Blade
1) Fixed-wing ridger with coupling. 2)Spring lawn weeder complete with guard. 3) 75 cm
1) Accelerator control lever. 2) Hoeing start control lever. 3) Reverse