Eurosystems Z2 Mode D'emploi page 13

HOW TO MOUNT THE ACCELERATOR WIRE (Fig. 5)
in the figure. Move the throttle lever(2) on the handlebar to the end of its stroke as shown by arrow "B " in the figure. Insert wire (3) into hole (4), secure the
sheath (5) with retainer (6) and screw (7). ATTENTION: in the position "stop" the throttle lever must stop engine.
FITTING THE BELT TIGHTENER CONTROL CABLE (Fig. 6-7)
must be connected to the control lever (2) fitted on the handlebar. FORWARD MOVEMENT fit the end (4) of wire (5) in the lower hole (3) of lever (2). Pass
the wire (5) complete with register (7) in the through hole of prong (6). In the case of motor hoes with REVERSE GEAR, fit the end (10) in hole (11) of the
reverse gear lever (1). Pass the wire (8) complete with register (9) in the through hole of prong (12). FOR MODEL Z3: terminal (4) has to be inserted
into the lever internal hole (2) as shown in the picture 7.
SETTING THE CONTROLS (Fig. 6)
can be performed by adjusting the wire register. Furthermore, the lever that controls hoeing start (2) must only start the cutter after completing half its
travel.
SETTING THE DREWBAR (Fig. 2)
can be adjusted by loosening the handle (2) so as to keep the machine in horizontal working position. Once adjustment has been made, tighten the handle
(2).
SETTING THE HANDLEBAR (Fig. 4)
(7) in the holes that best suit your working requirements. For side-adjustable version only: the handlebars can be turned to the right or left by lifting the
lever shown in (Fig. 11 part 1). If the lever device (1) seems not to be working , please unscrew or screw up the nut (2) which is placed under rhe
handlebar support (Fig. 10).
INSTRUCTIONS
Following the assembly & adjustment operations the motorcultivator is ready to start working.
ATTENTION ! Before switching the engine on, carefully check if the motorcultivator is in perfect good repair.
- Engine instructions: Carefully read the istructions booklet anclosed to the relevant engine.
- Check if the air filter is clean.
- Fill the tank in as per the fuel described in the engine specifications and using a filter filling funnel.
- Do not change the calibration of the speeds control rotation device of the engine in order not to over-speed it.
- Starting the motor Open the fuel cock (for motors that feature such cock) and position the accelerator lever (Fig. 9 part 1) on the handlebar on START.
For cold starting, refer to the motor booklet. Grip the start handle and give a strong pull.
- Forward movement: grip the handlebars and pull the forward lever as far as it will go. (fig. 6, part 2 )
- Reverse movement: release the forward lever (fig. 6, part 2) and pull the other lever on the handlebar towards you.(1)
This motor hoe has been designed to produce minimum vibrations and noise. Nevertheless, it is a good idea to interrupt long jobs with short pauses.
End of work: after work, to stop the motor, move the accelerator lever (fig. 5 part 2) to STOP position.
CHANGING THE OIL IN THE LOWER DRIVE (Fig. 9)
Position the lever (1) on the engine at the end of its stroke as shown by arrow "A "
Important! The cutter must only start turning after the relevant controls have been set. This setting
To achieve correct hoeing and correct forward movement of the motor hoe, the height of the drewbar (1)
The handlebars can be height-adjusted. Loosen the knobs (10) and (11) and fit the through screw
Generally speaking, the oil should be changed every 100 work hours (oil
The control wire is already fitted to the belt tightener spring, but this
7