Eurosystems Z2 Mode D'emploi page 12

6 During the machine transport and all the maintenance, cleaning, equipment change operations, the engine must be switched off.
7 Before leaving the machine, please switch the engine off.
8 Do not switch the machine on in closed rooms/areas where you can have carbon monoxide exhalations.
9 WARNING !! The petrol/gasoline is highly inflammable: Don't fill the tank neither in closed areas, nor when engine is on, don't smoke and be careful
to the petrol/gasoline loss from the tank. In case of leak, don't try to switch the engine on but move the machine away from the area in order to avoid
ignition source until the gasoline vapours fade away. Re-place the tank caps and the gasoline box.
10 Keep attention to the exhaust pipe. The parts near the pipe can reach 80°C.
Replace the defective and/or worn out silencers Burn hazards !!!.
11 Do not work on excessively steep slopes and take every precaution when changing direction or pulling the machine towards you.
12 Before putting the machine into operations, check it visually and make sure all the accident prevention measures are working. It is absolutely
forbidden to exclude and/or to tamper with them. Replace worn or damaged elements.
13 In case the machine is incorrectly used, and/or the repairs are performed by non-authorized technical staff, and/or fitted by equispare parts other
then original ones: any use other than that described above is prohibited and will involve the cancellation of the warranty and the refuse all
responsability from the manufacturer.
SAFETY DEVICE (Fig. 6)
when the relevant levers are released (1) and (2).
NOTES FOR WORKING WITH THE MOTOR-HOE (Fig. 6)
motor hoe firmly, push the spur into the ground. Pull the clutch lever (2) on the handlebar to begin hoeing. APPLICATIONS: working light or medium-heavy
ground, hoeing, breaking up, weeding, digging in composts or fertilisers, etc.
HOW TO ASSEMBLE YOUR MOTOR-HOE
packing case. For assembly to be completed, the step/by/step procedure is as follows.
FITTING THE DREWBAR (Fig. 2-3)
turning the handle (2). The purpose of the transfer wheel (Fig. 3 part 1) is for transporting the motor hoe only. This can be fitted after turning the drewbar by
180° and locking it in place with the wing screw (2). During motor hoe operation, the wheel should be removed: loosen the wing screw, take off the drewbar
and reposition it turned round as in Fig. 2
FITTING THE HANDLEBAR SUPPORT (Fig. 4)
washers (3) and nuts (4). Fit the cable guide (5) as shown in the illustration.
FITTING THE HANDLEBAR (Fig. 4)
6 and nut (9) in the upper hole of the handlebar. Proceed in the same way for the lower hole (A), by fitting the other screw (7),spacer (13) and the washers h.4
(12) in the knob (10) and knob (11), complete with nut, in the sequence shown in the illustration. For further details, see the handlebar adjustment chapter.
All the motor-hoes feature accident-prevention devices. Such devices cause automatic disconnection of the drive
Unless otherwise agreed, the motor cultivator is delivered disassembled and placed in a
Fit the long side of the drewbar (Fig. 2 part 1) into the end part of the frame arm and lock in place by
Fit the support (1) on the motor hoe using 4 screws (2) already positioned on the plate,
Fasten the 2 handlebars (6) to support (1) by inserting the through screw (7) ,spacer (13), washers (8)
With the motor running, rest the blades on the ground and, holding the