Wall Mounting - Amplicomms BigTel 48 Mode D'emploi

I
NSTALLATION

3.4 Wall mounting

Your telephone is also suitable for wall mounting.
Use the two screws for fixing it to the wall. Drill two holes 83 mm apart and
leave the screws protruding 5 mm from the wall. Now place the telephone
over the screws and push down slightly.
Fig. B
Fig. A
When the telephone is used on a table, the receiver hanging hook must be
in the flush position as shown in figure A (factory setting). When mounting
on the wall, the telephone receiver hanging hook is pulled out and rotated.
See figure B.
3.5 Hearing aid compatible
The telephone has a special circuit working on the basis of induction for
transmitting speech to hearing aids. Please set your hearing aid to "T".
3.6 Supplementary services set up
Your telephone supports supplementary services provided by your telepho-
ne network provider, (e.g. brokering, call waiting, three-way conference,
etc.). For these, you will need the "FLASH" setting on your telephone. More
information can be found in item 4. Please contact your telephone network
provider to gain access to these functions (some of which are subject to
charge).
18