Regenerant Line Connections; Electrical Connection - Pentair 368 Notice D'utilisation

Regenerant Line Connections

Make the connections and hand tighten. Be sure that the regenerant line is secure and free from
air leaks. Even a small leak may prevent the conditioner from drawing the regenerant from the
tank. This may also introduce air into the valve causing problems with valve operation.
Ensure that Teflon* tape pipe sealant is applied to the 9.525 mm (3/8-inch) BSP regenerant line
connection
*Teflon is a trademark of E. I. duPont de Nemours.

Electrical Connection

The 608 Series control operates on 12-volt alternating current power supply. This requires use of
the Autotrol supplied AC adapter. A variety of AC adapters are available for different applications.
Make sure power source matches the rating printed on the AC adapter.
NOTE: The power source should be constant. Be certain the AC adapter is not on a
switched outlet. Power interruptions longer than 6 hours may cause the control's super
capacitor to fully discharge and loose the Time of Day setting. When power is restored,
the control will briefly display the two digit model number and then display the Time of
Day setting as "0". The Time of Day will need to be programmed.
10
Rev B
Pentair Residential Filtration, LLC