Technical Data; Assembly - Kerbl RotaBrush Classic Mode D'emploi

Technical data

No. motors
Voltage supply
Frequency
Capacity
Consumption
Overall weight
Brush dimensions
Brush movement speed
Assembly instructions:
RotaBrush Classic and Twin are supplied completely assembled and ready for installation (See fi g.).
The oscillating brush is supplied with the machine body completely assembled and ready for
installation, except for the assembly of:
• roller, which must be inserted on the roller shaft
• support bracket which must be fastened to the wall for hooking the brush support.
• electric cable to be positioned and fastened inside the clips already on the support arm
(Attention to instructions in Fig.5)
To assemble the roller, remove the nut and washer which, after inserting the roller on the shaft, must be screwed
and tightened again on the shaft. The roller can be inserted in either direction.
Assembly instructions are given in fi gures 3-4-5-6.
fi g. 1 – RotaBrush Classic: assembling
Classic
1
220V – 110V
50 – 60 Hz
0.5 Cv
0.37 kw/h
75 kg
50 x 100
50 rev/min
Swing
1
220V – 110V
50 – 60 Hz
0.5 Cv
0.37 kw/h
80 kg
50 x 100
50 rev/min
fi g. 1 – RotaBrush Twin: assembling and fi xing detail
fi g. 2 – CowCleaner Swing : with particular plate for wall mounting
23
Classic
2
220V – 110V
50 – 60 Hz
2 x 0.5 Cv
2 x 0.37 kw/h
130 kg
130 x 138 cm
50 rev/min