Folding And Unfolding; Check-Out - Quickie M6 Mode D'emploi

E N G L I S H
3. Adjusting Anti-Tip Tube Wheel
The anti-tip tube wheels may have to be raised or
lowered to achieve proper clearance 1 1/2" to 2".
a. Press the anti-tip wheel release pin so that the release pin is drawn inside.
b. Raise or lower to one of the three predrilled holes.
c. Release pin.
d. Adjust the second anti-tip tube wheel the same way. Both wheels should be at exactly
the same height.
4. Turning Anti-Tip Tubes Up
Turn anti-tip tubes up when being pushed by attendant, overcoming obstacles or climbing curbs.
a. Press the rear anti-tip tube release pin.
b. Hold pin in and turn anti-tip tube up.
c. Release pin.
d. Repeat with second anti-tip tube.
e. Remember to return anti-tip tubes to down
position after completing maneuver.
K. FOLDING AND UNFOLDING
1. Folding Chair
a. Remove quick-release wheels (optional).
• Depress quick-release button.
• Remove wheel by sliding out quick-release axle from axle bracket.
• Repeat with other wheel.
b. Flip up the footplates to a vertical position before folding the wheelchair.
c. Grasp the seat sling (in the center) and lift sharply until the wheelchair is folded.
d. Unlatch stabilizer bar– Depress thumb button. Swing bar out of the way.
2. Unfolding Chair
a. Replace quick-release wheel (optional) by depressing the quick-release button on the
axle.
b. Slide it into the axle sleeve until it locks.
c. Repeat with other wheel.
d. Tilt the wheelchair toward you far enough to take the weight off the opposite wheel.
e. Push down on the seat rail (closest to you) until the wheelchair is completely opened.
f. Make sure seat rail tubes are resting in the frame saddles.
g. Reattach stabilizer bar– Swing bar back into place. Depress thumb button to latch.
Possible pinch point. If seat sling is not present during folding or unfolding, pinch
top of seat rail securely without wrapping fingers around the seat rail.
Use flat palms to depress the chair if opening.
To prevent injury: if tension adjustable upholstery is present, loosen straps or
remove upholstery prior to folding or unfolding the chair.
L. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily.
All accessories should also perform smoothly. If you have any problems, follow
these procedures:
1. Review the Set-Up and Check-Out sections and Operating Guide to make
sure chair was properly prepared.
2. Review Troubleshooting Guide.
3. If your problem persists, contact your authorized supplier. If you still
have a problem after contacting your authorized supplier, contact Sunrise cus-
tomer service. See the introduction page for details on how to contact your
authorized supplier or Sunrise customer service.
14
15
WARNING
WARNING
IX. SET-UP, DJUSTMENT ND USE
15
14
15
930457 Rev. C