Plastic Side Guards; Q.folding And Unfolding; Check-Out - Quickie Q2 Lite Mode D'emploi

E N G L I S H
4. Squaring Anti-tip Tubes
When camber is added to rear wheels, anti-tips must be adjusted to be square to the center line of the
chair.
a. Loosen both screws (K) so that anti-tip receiver can be rotated.
b. Rotate anti-tip receiver and anti-tip until anti-tip is square to the floor at the center of the chair.
c. Retorque fasteners on anti-tip receiver to 100 in-lbs.
d. Repeat for opposite side.
P . PLASTIC SIDE GUARDS (OPTIONAL)
Installation of side guard hardware.
a. Position outer receiver hardware (A) on frame.
b. On corresponding inside of the frame position inner clamping hardware (B)
c. Insert two bolts with washer and tighten using 3/16 inch hex key
Inserting and Removing of Side Guard
a. Insert Side Guard (D) into Side Guard outer receiver hardware (A)
b. Remove, clutch top of Side Guard and pull upward.
NOTE – After installing receiver hardware and inserting side guard check for interference. Don't operate the
wheelchair that as interference with these other components.
Q. FOLDING AND UNFOLDING
1. Folding Chair
a. Remove quick-release wheels (optional).
• Depress quick-release button on the axle.
• Remove wheel by sliding out quick-release axle from axle bracket.
• Repeat with other wheel.
b. For the Q2 Lite Swing Away model, flip up the footrest to a vertical position before folding the
wheelchair.
c. Grasp the seat sling (in the center) and lift sharply until the wheelchair is folded.
2. Unfolding Chair
a. Replace quick-release wheel (optional) by depressing the quick-release button on the axle.
b. Slide it into the axle sleeve until it locks.
c. Repeat with other wheel.
d. Tilt the wheelchair toward you far enough to take the weight off the opposite wheel.
e. Push down on the seat rail (closest to you) until the wheelchair is completely opened.
f. Make sure seat rail tubes are resting in the seat rail saddles.
NOTE– Ensure that footrest is locked prior to use.
Possible pinch point. If seat sling is not present during folding or unfolding,
pinch top of seat rail securely without wrapping fingers around the seat rail.
Use flat palms to depress the chair if opening.
To prevent injury: if tension adjustable upholstery is present, loosen straps or
remove upholstery prior to folding or unfolding the chair.
R. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should
also perform smoothly. If you have any problems, follow these procedures:
1. Review the set-up and check-out sections and operating guide to make sure chair was
properly prepared.
2. Review troubleshooting guide.
3. If your problem persists, contact your authorized supplier. If you still have a problem
after contacting your authorized supplier, contact Sunrise customer service. See the
introduction page for details on how to contact your authorized supplier or Sunrise cus-
tomer service.
31
32
WARNING
WARNING
C
19
31
K
32
D
B
A
I X .
108590 Rev. C