Table des Matières
Publicité
Certificate No:
Date of Issue:
Manufacturer:
Additional Manufacturing location(s):
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the
IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and
found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx Scheme
Rules, IECEx 02 and Operational Documents as amended.
STANDARDS:
The apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found to comply
with the following standards:
IEC 60079-0 : 2011
Edition:6.0
IEC 60079-15 : 2017
Edition:5.0
IEC 60079-7 : 2015
Edition:5.0
This Certificate does not indicate compliance with electrical safety and performance requirements other than those expressly included in the
TEST & ASSESSMENT REPORTS:
A sample(s) of the equipment listed has successfully met the examination and test requirements as recorded in
Test Report:
US/FMG/ExTR18.0005/00
Quality Assessment Report:
DE/BVS/QAR16.0002/02
IECEx FMG 18.0005X
2018-10-04
Bühler Technologies GmbH
Harkortstrasse 29
Ratingen, D-40880
Germany
Explosive atmospheres - Part 0: General requirements
Explosive atmospheres - Part 15: Equipment protection by type of protection "n"
Explosive atmospheres – Part 7: Equipment protection by increased safety ''e''
Standards listed above.
IECEx Certificate
of Conformity
Issue No: 0
Page 2 of 4
Publicité
Table des Matières
