Dismantle The Bed - Invacare Etude Plus HC Manuel D'utilisation

Invacare® Etude Plus® HC
1. Connect the cables of the bed end motors (head and foot end)
directly to the control box.
2. The plug of the thigh motor must be directed through the
opening of the supporter for the backrest motor and then
connected to the control box.
3. Connect the main cable plug to the power socket.
4. Run the motors of the bed ends to their top position.
5. Place the motor cable of the foot end on the hook at the foot end.
6. Run the backrest to its top position.
8
7. Place the head end motor cables on the four hooks at the head
end.
8. Attach the locking cam over the plugs in the control box.

3.4 Dismantle the bed

1. Dismantle side rails or wooden side panel and lifting pole.
2. Bring the bed to its lowest position and adjust all mattress
support sections to horizontal position.
3. Disconnect main power supply. Roll the cable onto the hook of
the head end of the bed.
4. Dismantle the locking cam from the control box with a tool,
e.g. a flat headed screwdriver.
5. Disconnect all cables from the control box.
6. Separate the mattress support from the bed ends.
7. Divide the upper and lower halves of the mattress support.
1579562-A