Table des Matières
Publicité
ENGLISH
2. APPLICATION RANGE
2.1)
The tool HT131-UC is supplied with the AU130-C adaptor, which will accept the semi-
circular slotted dies (common to Cembre 130 kN tooling) suitable for:
– Indentation on copper conductors
– Circular Compression on copper conductors
– Hexagonal compression on copper, aldrey or aluminium conductors.
2.2)
With the upper adaptor AU130-... and lower adaptor AC130-P, the tool HT131-U
or HT131-UC can accept:
– Pre-rounding dies UP 130-...
(used for converting aluminium sectoral conductor to a compact, round section).
– Containing dies (MV, MVC, MVM, MUA series) and the relevant Indentors PS130-.../E
(to crimp connectors on aluminium cables using the deep indent crimping system).
3. INSTRUCTIONS FOR USE
(Ref. to Fig. 1, 2 and 3)
Instruction for use are referring to the tool featuring an AU130-C adaptor but they are
completely suitable also for tool equiped with AU130-... and AC130-P adaptors (regard-
less of selected dies).
3.1) Setting
With the tool is in rest position
– Select the appropriate die set for the connector.
– Insert the die set (88 and 89) into the head, as § 4.3.
– Insert the conductor in the connector.
– Position the connector between the dies and ensure the correct location of the crimp.
3.2) Die advancement
– Set the tool on release position
able handle (53).
– Rotate main handle (04) to operating position
– Operate moveable handle (56) for lower die advancement. This fi rst stage rapidly closes
the dies to the connector.
▲
!
N
EVER PRESSURIZE THE TOOL WITHOUT INSERTING THE DIES AS THIS COULD CAUSE
DAMAGE TO THE TOOL HEAD AND THE RAM
Make sure the dies are exactly positioned on desired crimp point, otherwise re-open
dies following instructions as per § 3.4 and position the connector again.
operate as follows:
by rotating main handle (04); open the move-
.
.
FIG. 6 STORAGE CASE - RANGEMENT - LAGERUNG - ALMACENAMIENTO - CUSTODIA
53
FIG. 7
TOOL POSITION FOR MAINTENANCE OPERATIONS - POSITION DE L'OUTIL POUR L'ENTRETIEN -
WERKZEUG WARTUNGSPOSITION - COLOCACION PARA LAS OPERACIONES DE MANTENIMIEN-
TO - POSIZIONAMENTO PER LE OPERAZIONI DI MANUTENZIONE
3
40
VAL130
04
70
62
28
VALP3
01
03
Publicité
Table des Matières
