Cembre HT131-U Notice D'utilisation Et Entretien page 7

- Reference symbol
- Repère fi xe
- Reference ideogram
- Simbolo de referencia
- Simbolo di riferimento
▲
▼
▲
▲
▼
LOCK
- Rest - Release
- Operating
position position position
- Repère - Repère de
- Repère de
de repos
décompression travail
- Ruhestellungs - Druckablass - Arbeits
position
position position
- Posición - Posición - Posición
de reposo de liberación
de trabajo
- Posizione - Posizione - Posizione
di riposo di rilascio
di lavoro
FIG. 1 OVERALL VIEW
VUE D'ENSEMBLE
GLOBALANSICHT
VISTA DEL CONJUNTO
VISTA D'ASSIEME
33
28
51
04
37
– To insert the adaptor AC 130-P (91), press the die release pin (30).
Insert the adaptor into the seat of the ram (28), until secured by the retaining pin (32).
To facilitate this operation, an advancement of 3 ÷ 4 mm (0.12 - 0.16 in.) of the ram (28)
34
is suggested. To remove the adaptor, press the die release pin (30) and slide the adaptor
from the ram (28).
5.4) Dies, indentors, pre-rounding dies - fi tting and removal
– The containing die (96) and upper pre-rounding die (95): are located in the adaptor
AU130-... (98) by grooves in the upper face.
– The lower pre-rounding die (94): is inserted or removed from the adaptor AC130-P
(91), by pulling the release button (92).
13
– The indentor PS130.../E (93): is inserted into the seat on the ram (28) (see § 4.3.2).
6. WARNING
70
The tool is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performance
of the tool.
6.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be cleaned with a clean cloth, taking care to remove
any residual, especially close to pivots and moveable parts.
53
6.2) Storage
(Ref. to Fig. 6)
When not in use, thetool should be stored and transported in it's case to prevent damage.
Following cases are available:
– VALP3 plastic case: size 620x380x135 mm (24.4x14.9x5.3 in.), weight 2,5 kg (5.5 lbs).
– VAL130 steel case: size 360x280x48 mm (14.17x11x1.89 in.), weight 3 kg (6.62 lbs),
for storage of the accessories for crimping aluminium connectors.
6.3) Head rotation
For ease of operation, the tool head can rotate through 180°.
Warning: do not attempt to turn the head if the hydraulic circuit is pressurised.
7. MAINTENANCE
Air in the hydraulic circuit may affect the performance of the tool; e.g. no lower die advance-
ment, slow advancement of the lower die; lower die pulsating.
In this case proceed as follows:
6
(Ref. to Fig. 7 and 8)
ENGLISH
(Ref. to Fig. 5)