John Bean EHP System IV-E Manuel D'utilisation page 6

Tires and Rims that are not the same diameter are mismatched.
• NEVER attempt to mount or inflate any tire and rim that are mismatched.
• ALWAYS check to see that tire and rim diameters are the same.
A mismatched tire and rim will explode causing death or serious personal injury
Over-pressurized tires can explode causing flying debris.
Read and understand Operator's Manual before operating.
•
Keep bystanders away from work area.
•
• AlWAYS wear Safety Goggles.
• ALWAYS check to see that Tire and Rim diameters are the same.
• NEVER attempt to mount or inflate any Tire and Rim with different diameters.
• Inspect tires, NEVER inflate tires that are damaged, rotten or worn.
NEVER inflate 'Split Rim Wheels' on this tire changer, remove them and use only an approved safety
•
inflation cage designed for this purpose.
• Lock turntable Clamp on inside of rim before attempting to inflate tire.
• Use approved tire bead lubricant before removing or installing tire on rim.
• ALWAYS position the "Safety Restraint Arm" over the wheel to hold it to the turntable while inflating
if so equipped.
If a tire explodes on this tire changer, STOP using it until the "Safety Restraint Arm" has been
•
replaced, which must be done even if no damage is seen.
• NEVER place head or body over a tire during inflation process.
• Use short bursts of air to seat tire beads, check tire air pressure frequently.
• NEVER exceed tire manufacturer's pressure limits.
NEVER attempt to bypass or alter the built in air pressure limiter. Only inflate tire with air hose
•
supplied with tire changer. NEVER use shop inflation hose to inflate a tire.
• Tire Changer must be anchored to concrete floor if equipped with a "Safety Restraint Arm"
Exploding Tires can cause serious injury.
6-EN