John Bean EHP System IV-E Manuel D'utilisation page 19

4.1-6
4.1-7
4.1-8
NOTE:
O N C E T H E M O U N T / D E M O U N T H E A D I S
POSITIONED PROPERlY, IDENTICAl WHEElS
MAY bE CHANGED WITHOUT HAVING TO RESET
THE HEAD.
F. Insert the bead-lifting tool under the bead and
over the support of the mount/demount tool. Lift
the bead onto the mounting finger. To facilitate this
operation, press with left hand on the bead in position
diametrically opposite to that of the tool. If desired, the
bead-lifting tool can be removed after lifting the bead
onto the finger (Fig. 4.1-6).
G. Rotate the turntable clockwise and at the same time
push down on the tire sidewall to move the bead into
the drop-center of the rim (Fig. 4.1-7).
H. Repeat the process for removing the lower bead.
With left hand, lift the bead in position diametrically
opposite the tool to keep it in the drop center (Fig.
4.1-8). Move the swing arm aside and remove the tire.
EN-19