Electrical Connections; Grounding Instructions - Jet JCDC-1.5 Instructions De Fonctionnement

5.0 Electrical connections

All electrical connections must be
done by a qualified electrician in compliance with all
local codes and ordinances. Failure to comply may
result in serious injury.
Mains connection and any extension cords used must
comply with applicable regulations.
The mains voltage must comply with the information
on the machine license plate. The dust collector comes
with a plug designed for use on a circuit with a
grounded outlet.
Keep in mind that a circuit being used by other
machines, tools, lights, heaters, etc. at the same time
will add to the electrical load. A dedicated circuit to
the dust collector will offer best results since dust
collectors are generally used while other tools are
running.

5.1 Grounding Instructions

This appliance must be grounded. If it should
malfunction or breakdown, grounding provides a path
of least resistance for electric current to reduce the
risk of electric shock. This appliance is equipped with
a cord having an equipment-grounding conductor and
grounding plug. The plug must be inserted into an
appropriate outlet that is properly installed and
grounded in accordance with all local codes and
ordinances.
Improper connection of the
equipment-grounding conductor can result in a risk
of electric shock. Check with a qualified electrician or
service person if you are in doubt as to whether the
outlet is properly grounded. Do not modify the plug
provided with the appliance – if it will not fit the
outlet, have a proper outlet installed by a qualified
electrician.
The conductor with insulation having an outer surface
that is green with or without yellow stripes is the
equipment-grounding conductor.
replacement of the electric cord or plug is necessary,
do not connect the equipment-grounding conductor
to a live terminal.
Repair or replace damaged or worn cord immediately.
Make sure that the appliance is connected to an outlet
having the same configuration as the plug. No adapter
should be used with this appliance. If the appliance
must be reconnected for use on a different type of
electric circuit, the reconnection should be made by
qualified service personnel; and after reconnection,
the appliance should comply with all local codes and
ordinances.
6.0 Operations
6.1 Switches
Main power switch (Figure 15)
You can start the machine with the green ON button.
The red OFF button stops the machine.
6.2 Dust hose connection
Use proper type hose to connect dust collector to
machine(s) being operated. Dryer vent hose is not
acceptable for this purpose. Secure hose at both ends
with proper clamps.
If an inlet port is not being used, it should remain
capped. An open port will diminish the machine's
efficiency, and may create a safety hazard.
Contact your nearest JET distributor for a line of Dust
Collector hoses and accessories. You can customize
your installation and obtain maximum performance
with dust hoods, hoses, clamps, fittings, and blast
gates.
If repair or
13
Figure 15