Static Gobo-Wheel; Dimmer / Shutter / Strobe; Stand Alone-Mode - Futurelight MH-420 Spotlight Mode D'emploi

Static gobo-wheel

The gobo-wheel includes 11 metal gobos and 1 open position. The gobos have an outside diameter of 26,5
mm and an image diameter of 22 mm.

Dimmer / Shutter / Strobe

Smooth 0 - 100 % dimming is provided by the combined mechanical dimmer / shutter unit. This unit may also
be used for strobe-effects (1 - 10 flashes per second)

Stand Alone-mode

In the Stand Alone-mode, one or several projectors of the data link can be operated without controller. Every
projector features three pre-programmed programs which can be edited individually. Every projector can call
up a different program. In order to set the desired program, please refer to the explanations under "Stand
Alone-setting" (menu "St.AL.").
The Stand Alone-mode includes the operation of an individual projector or a chain of several projectors in
master/slave-operation.
For the synchronized operatio of several projectors, the projectors have to be connected with each other via
a data cable. One projector has to be defined as master-device and the others as slaves. Every slave needs
to have its own slave-address "SLA-1" to "SLA-9". Please note that every slave-address can only be
assigned to one projector.
The device's display shows the current program.
Please note: If the master-device runs through a reset, switches the lamp on or off or runs through the test
program, all slave-devices follow the master. Furthermore, you cannot call up programs via the Control
Board or edit them if the master-device is switched on and connected with the slaves.
The master-device starts the program run simultaneously at all slaves. All devices start their programs at a
defined starting point. Every slave runs through the internal programs until the master-device requires a
restart. If the slave's internal program is longer than the master's, the last step will not be executed and the
program will be restarted.
Restart
Starting point
Please note: Disconnect the master and slaves from the DMX-controller before you start master/slave-
operation. Otherwise danger of data collisions.
Caution: At the master-device and at the last slave-device, the DMX-cable has to be terminated with a
Ω
terminator. Solder a 120 resistor between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the
DMX-output.
54