Futurelight MH-420 Spotlight Mode D'emploi page 62

Fixture code
-
The option contains identification code (1-9999) for the fixture, which is used for the master/slave operation.
- Adjusting the default positions of colour, gobo and effect wheels
By this function you can calibrate and adjust the colour and gobo wheels to their standard/right positions.
Use the [Up] and [Down] keys to browse through the adjusting menu - the display shows step by step these
messages: „PAn, Tilt, FPAn, Ftilt, SPEd, Colo, dimr, FCAL" by which you can adjust the fixture to the
required / desired position (0-255) before the function calibration. Then when the positioning is finished use
the last "FCAL" function (Fixture calibration).
1. Calibration via the control board
Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Colo, SGob" for
very smooth function calibration. Select one of them, press [Enter] and use the [Up] and [Down] keys in
order to adjust their right value from 0 to 255. Then press [Enter] to confirm or [Mode] to cancel and return
to the menu. This can be repeated for each calibration parameter if it is required. When the calibration is
finished, it is necessary to use the "ArES" function in order to write the calibration values to the memory
(EEPROM) and to make a reset in order to check the newly adjusted positions of the colour, gobo and effect
wheels. When the reset of the fixture is finished, the display will show the "FCAL" message. Press [Enter] to
repeat the calibration or [Mode] to return to the "AdJ" menu.
2. Calibration via the external controller
Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Colo, SGob" -
calibration parameters. Select one of them and press [Enter].
Now you can calibrate the colour, gobo and effect wheel by your controller. The DMX calibration protocol is
described in the table mentioned below.
DMX Calibration Protocol:
After having calibrated required functions press [Enter] to confirm (or [Mode] to cancel and return to the
menu without reset by the "ArES" function) and use the "ArES" function in order to write the calibration
values to the memory (EEPROM) and to make a reset in order to check the new adjusted positions of the
colour and static gobo wheels and gobo indexing.
62