Futurelight MH-420 Spotlight Mode D'emploi page 58

- Display intensity
With this function, you can adjust the display-intensity from 20 % to 100 %. Use the [Up] and [Down]
keys to select the level of the display-intensity and press [Enter] to confirm or [Mode] to cancel and
return to the menu.
- Display-reverse
With this function, you can rotate the display by 180°. Use the [Up] and [Down] keys to select
"normal display" or "display turned by 180°" and press [Enter] to confirm or [Mode] to cancel and
return to the menu.
- Display-On
This function allows you to keep the display on or to turn off automatically 2 minutes after last pressing
any key on the control board. Use the [Up] and [Down] keys to select "On" if you wish to keep the
display on or "Off" if you wish to turn off automatically 2 minutes after last pressing any key on the
Control Board and press [Enter] to confirm or [Mode] to cancel and return to the menu.
Blackout during movement correction
-
The function executes the blackout during the head movement correction (the moving head has lost its right
pan/tilt-position for a short moment). Use the [Up] and [Down] buttons to select "On" if you want to execute
the blackout or "Off" if you don't and press [Enter] to confirm or [Mode] to cancel and return to the menu.
- PAN/TILT-Feedback:
This function allows to return the Mowing Head to the required position after changing the position by
external force (e. g. by stroke). Use the [Up] and [Down] keys to select "On" if you wish to enable this
function or "Off" if you wish not to return the Moving Head to the required position and press [Enter] to
confirm or [Mode] to cancel and return to the menu.
Note: If feedback was switched Off, the PAN/TILT-position is changed by external force and feedbeck is
switched On again, the Moving Head might not to be synchronized with the DMX signal. You have to make a
reset in order to synchronize the Moving Head with the DMX signal.
- Mikrofon-Empfindlichkeit
With thiss function, you can adjust the microphone sensitivity from 1 (maximum) to 20 (minimum). Use the
Up-/Down Buttons to select the level of sensitivity. Press the Enter Button to confirm the chosen level or the
Mode Button to cancel and return to the menu.
Example:
Sensitivity too low
- Default settings
Press [Enter] to reset all fixture personalities (not the adjusting functions) to the default values. On the
display will appear „rSt" meaning that the fixture makes the reset. See the table of personality setting and
their default positions.
Signal level ok
58
Sensitivity too high