Equipment And Scope Of Delivery; Technical Data - Mettler Toledo InPro 8000 Série Instructions D'utilisation

InPro 8000 Series
1.2

Equipment and scope of delivery

Scope of delivery
The sensors of the InPro 8000 Series are delivered ready for use including
fiber optic cable. Each sensor is accompanied by this instruction manual.
A METTLER TOLEDO Process System for the measurement of turbidity or of
suspended particles is completed by a METTLER TOLEDO Turbidity Transmit-
ter Type M800 1-channel (order no. 30 026 633). Detailed information for
calibration of the measuring system can be found in the instruction manual
of the M800 transmitter (order no. 52 121 825).
Packaging
The packaging consists of cardboard and foamed plastic. Safekeep the
packaging for later use during storage or transportation of the sensor. Should
you wish to dispose of the packaging material, please observe your local
regulations as well as those data and instructions given in chapter 5.3 of
this manual.
Unpacking and inspection
Please check the sensors immediately during unpacking in order to
determine possible damage or missing items. Any irregularities should
immediately be notified to your carrier and to your supplier.
1.3

Technical data

Function
Sensors of the InPro 8000 Series are optical sensors which measure the
concentration of suspended particles in a liquid medium on the basis of
the principle of backscattered light. The Transmitter M800 1-channel is
equipped with a LED which beams a light – almost in the infra-red range
(wavelength 880 nm) – via a fiber optic cable into the liquid medium. If the
light hits on particles, then it is scattered in all directions. The light scattered
at an angle of 180° (backscattered light) is captured and led back via a fiber
optic cable to a photodiode in the transmitter, processed as photocurrent
and the signal transformed into a value for the transmitter display.
© 05/2017 Mettler-Toledo GmbH, CH-8606 Greifensee
Printed in Switzerland
6
InPro 8000 Series
52 800 247