Ex-Declaration; Use In Ex-Zones - Mettler Toledo InPro 8000 Série Instructions D'utilisation

InPro 8000 Series
Local legislation and regulations must be observed at all times. Such
stipulations do not form an integral part of this instruction manual.
It is on principle necessary for persons handling or using the sensors
to wear personal safety outfit such as protective goggles and protective
clothing.
The user is responsible for the instruction and training of personnel. In
this respect, additional copies of the instruction manual can be ordered
from your supplier. This instruction manual is an essential element of the
sensor equipment and must at all times be readily to hand for operators
directly at the location of employment of the sensors.
Before the sensor is removed from the process/process adapter, it must be
ensured that the process pressure has been reduced to a safe level and the
process temperature lowered to a safe range. Any escape of hot process
medium under pressure can cause damage to material/equipment or injury
to persons.
No modification whatsoever may be carried out on the sensors. Any
unauthorized modification or manipulation of the sensors results in im-
mediate expiry of the full scope of warranty granted by the manufacturer.
2.4

Ex-Declaration

2.4.1

Use in Ex-zones

Note: Before installation in Ex-zones, please read and observe the following
guidelines:
Ex-Classification:
II 1/2G Ex op is/ op pr IIA 95 °C Ga/Gb
II 1/2G Ex op is/ op pr IIB 38 °C Ga/Gb
Designation and number of the test certificate:
SEV 12 ATEX 0169 X
© 05/2017 Mettler-Toledo GmbH, CH-8606 Greifensee
Printed in Switzerland
10
InPro 8000 Series
52 800 247