Using For The First Time - PFAFF silberblau SILVERLINE HWK KLS 0,5 Mode D'emploi

Hydraulic workshop crane
English
Notes on use
IMPORTANT!
Only ever use the crane on a sufficiently firm (stable) floor/ground surface.
Use underlay material if necessary.
Make sure there is sufficient clearance for the cantilever arm.

Using for the first time

When not in use the workshop crane is folded together.
Important
Never move the cantilever out by hand as this may cause air bubbles to form in the cylinder.
Making ready for use:
(only ever use on a flat, horizontal floor/ground surface)
Important
Always hold unlocked wheel arms tightly! Risk of injury
Transportation position
5. Lift the undercarriage slightly
with your foot.
6. Insert the hinge pin and fasten.
CAUTION:
When it is folded together, only ever push the crane on a smooth and level floor/ground surface.
Any obstacles (uneven floor) may cause it to tip over.
technische Änderungen vorbehalten
Swinging down the upright bar
1. Unlock the upright bar (pull out the
locking pin ) and move to the
function position (direction of arrow).
2. Remove the retaining pin (slacken the
stop spring).
3. Unlock the pin .
7.
Lock and fasten the hinge pin.
design changes under reserve
F 09.02.036/000
4. Swing down the undercarriage
bar
(Check that there is sufficient
room to maneuver. There must
be no objects in the
maneuvering area. The operator
must ensure that any other
persons in the vicinity keep a
safe distance from the crane!)
8. Once the first undercarriage
bar has been locked and
fastened, swing down the
second undercarriage bar and
lock and fasten.
9. Check that all locks and
fasteners are fixed tightly.
10. To return to the transportation
state, follow the above
instructions in reverse order.
changements techniques sous réserve
!
!
Seite / page 12