Yamaha F6A Manuel D'utilisation page 156

F6/F8CMH
F8CW
EMU00977
Removing the Propeller
1) Straighten the cotter-pin 1 and pull it
out using a pair of pliers.
2) Remove the propeller nut 2 and washer
3.
3) Remove the propeller 4 and thrust
washer 5.
EMU00396
Installing the Propeller
CAUTION:
@
Be sure to install the thrust washer
before installing the propeller, other-
wise the lower case and propeller boss
may be damaged.
Be sure to use a new cotter pin and
bend the ends over securely. Other-
wise the propeller could come off dur-
ing operation
@
1) Apply Yamaha Marine grease or a corro-
sion resistant grease to the propeller-
shaft.
2) Install the thrust washer and propeller
on the propeller-shaft.
3) Install the washer and tighten the pro-
peller nut to the specified torque.
Tightening torque:
Refer to "SPECIFICATIONS" page 4-1.
4) Align the propeller nut with the propeller
shaft hole. Insert a new cotter pin in the
hole and bend the cotter pin ends.
NOTE:
@
When the propeller nut does not align with
the propeller shaft hole after tightening to
the specified torque, then tighten the nut fur-
ther to align it with the hole.
@
4-45
GB
and be lost.