Fitting The Handle And Handle Holder (Model 550Cb); Preparing The Connection To Chimney - Dovre 425CB Installation Et Mode D'emploi

Fitting the handle and handle
holder (model 550CB)
The appliance is supplied with a loose handle, the so-
called "cold hand".
1. Fit the wooden handle to the adaptor using screw
M8x50 provided; see following figure.
09-20015.088
2. Fit the handle holder (A) supplied to the bottom
plate using the nut and bolt M8; see the following
figure.
8
Preparing the connection to
chimney
When connecting the appliance to the chimney you
have the choice of connecting via either the upper side
or the rear. See the paragraphs "Connecting on the
upper side" and "Connecting at the rear".
Model 550CB also has the option of connecting at the
side. See the instructions in the paragraph
"Connecting on the side (model 550CB)".
The appliance is not supplied with a flue gas
opening at the rear or on the upper side. However,
model 550CB has two flue gas openings on its
sides (one on the left and one on the right). If you
do not use one or both of the side connections,
cover the side connections(s) that you are not
using with the cover supplied.
Model 550CB is supplied with two covers that have
the Dovre logo on them.
Sealant and materials supplied.
When connecting to the upper side an opening has
to be made in the heat shield. At the spot when the
opening has to be made an incision has been made
in the heat shield.
Preparation for connection at the
rear side
Make the necessary opening in the heat shield.
Subject to change because of technical improvements