Dovre 425CB Installation Et Mode D'emploi page 33

1. Unhook the heat shield from the appliance.
2. Make the opening in the heat shield by cutting the
pre-cut section out of the heat shield using plate
shears.
3. Replace the heat shield back onto the appliance.
Connecting on the upper side or
the rear side
First make the flue gas opening in the appliance by
removing the connection cover. Use the equipment
provided: the tension piece, the washer, the nut and
bolt; see following figure.
1. In the centre of the connection cover, drill a hole
with a diameter of 10 mm.
2. Place the tension piece and the bolt on the inner
side of the connection cover.
3. Slide the washer over the bolt and tighten the nut
onto the bolt.
On enamelled appliances, place a piece of
cardboard measuring a minimum of 20 cm by
20cm between the washer and the appliance to
protect against chipping of the enamel.
4. Tighten the nut by hand. Use a small amount of
grease to make it easier to turn the nut.
5. Using a ring spanner, tighten the nut so that the
connection cover breaks out.
6. Once made a flue gas opening can be closed off
again with the supplied shut-off cover. Use the
mounting place and bolt M6x25 to fit the cover to
the appliance.
Subject to change because of technical improvements
For model 550CB: cover the two flue gas
openings on the sides with the supplied covers
that have the Dovre logo on them.
7. Fit the connection collar (C) to the flue gas
opening (D) using the two brackets supplied (E)
and the fixing materials (A) and (B); see the
following figure.
8. Use the supplied stove sealant for sealing the
connection collar and the cover with the appliance.
Connecting on the side (model
550CB)
The appliance is supplied with a flue gas opening on
the left and right side.
1. Fit the connection collar (C) to the flue gas
opening (D) using the two brackets supplied (E)
and the fixing materials (A) and (B); see the
9