Installation; Preparation; Fitting The Legs - Dovre 425CB Installation Et Mode D'emploi

operate the bolt when it is warm and to remove the
ash pan; see the following figure.
Additional features of the 550CB
model
This appliance is suitable for a side connection to
the flue gas outward flow, but can also alternatively
be connected on the upper or rear side.
The appliance is supplied with a loose handle, the
so-called "cold hand".
In order to open the door, place the "cold hand" (A)
in the bolt (B) on the door; see the following figure.
Subject to change because of technical improvements

Installation

Preparation

Please check the appliance for damage caused
during transport or any damage or defects
immediately after delivery.
If you detect damage caused during transport
or any other damage or defects, do not use the
appliance and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire basket, ash pan, fire grate) from the
appliance before you start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of those removable parts, so
that you have no difficulties in installing the
parts in the right place later on.
1. Open the door.
2. Remove the fire-resistant inner plates.
Cast iron inner plates protect the combustion
chamber and dissipate heat to the
environment.

Fitting the legs

Fit the legs to the appliance; see the following figure.
1. Using the bolts supplied M6, fit the two parts of
the legs to the desired height.
2. Tilt the stove on its back.
3. Fit the four legs on the bottom plate using the
washers and the M8 nuts that are found on the
bottom plate.
7