Lubrication; Cleaning Glass - Dovre 425CB Installation Et Mode D'emploi

2. Pull the baffle plate forwards so that the bolt
comes free from the rear side.
3. Remove the baffle plate via the front door.

Cleaning glass

Dirt clings less easily to well-cleaned glass. Proceed
as follows:
1. Remove dust and loose soot with a dry cloth.
2. Clean the glass with stove window cleaner:
a. Apply stove window cleaner to a kitchen
sponge, rub down the entire glass surface and
give the cleaning agent time to react.
b. Remove the dirt with a moist cloth or kitchen
tissue.
3. Clean the glass again with a normal glass cleaning
product.
4. Rub the glass clean with a dry cloth or kitchen
tissue.
Do not use abrasive or aggressive products to
clean the glass.
Wear household gloves to protect your hands.
14
If the glass in the appliance is broken or
cracked, it must be replaced before you can
use the appliance again.
Make sure that no stove window cleaner runs
between the glass and the cast-iron door.
Maintaining enamelled fire
Never clean the appliance when it is still hot. The
enamelled surface of the fire can be cleaned most
effectively with a mild green soap and lukewarm
water. Use as little water as possible, rub the surface
dry and prevent the formation of rust. Wire wool or
other abrasives should never be used. Never place a
kettle directly onto an enamelled fire; use a stand and
prevent damage from occurring.

Lubrication

Although cast-iron is slightly self-lubricating, you will
still have to lubricate moving parts frequently.
Lubricate the moving parts (such as guide
systems,hinge pins, latches and air slides) with
heat resistant grease that is available in the
specialist trade.
Adjusting the air slider
If the air slider (C) of the secondary air inlet does not
move easily, you can adjust the air slider using the
two screws (A) and (B) in the front plate; see following
figure.
Touching up damaged paint
Small areas of damaged paint finish can be touched
up with a spraying can of special heat-resistant paint
finish available from your supplier.
Touching up the enamelled surface
Enamelling is a process carried out by traditional
methods, meaning that it is possible that small colour
Subject to change because of technical improvements