Publicité
Les langues disponibles
Les langues disponibles
Increase the separation between the equipment and
receiver�
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected�
Consult the dealer or an experienced radio/TV
technician for help�
This device complies with Part 15 of the FCC Rules�
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation�
Caution: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment�
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt RSS(s)�
Operation is subject to the following two conditions:
(1) This device may not cause interference�
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device�
RF exposure warning
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment�
This equipment must be installed and operated in
accordance with provided instructions and the antenna(s)
used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons
and must not be collocated or operating in conjunction
with any other antenna or transmitter�
MPE caution (for mobile device under Part 15�247 &
15�407 device)
To satisfy FCC & ICRF exposure requirements, a
separation distance of 20 cm or moreshould be
maintained between the antenna of this device and
persons during device operation�
To ensure compliance, operations at closer than this
distance is not recommended�
To disable the Wi-Fi module on DEEBOT, follow these
steps: power on the robot, then place it on the OMNI
Station, ensuring that the Charging Contacts on DEEBOT
and the Station are properly connected, and press and
hold the
for 20 s until you hear beeps�
To enable the Wi-Fi module on DEEBOT, please restart
the robot� Additionally unplug and plug in the Station�
SAVE THESE INSTRUCTIONS
7 EN
Publicité
